Reeder Custom Guns - The priming in these .22's seems "light" ..

Jim Taylor
The priming in these .22's seems "light" ..
Thursday, August 05, 2021, 15:02

using a CCI .22 .. pull the bullet, dump the powder and re-seat the bullet, the priming will push the bullet out of the barrel.

These will not do that. They get it about halfway down the bore.

Bullseye is very easy to ignite which is probably why it is working better.

Chronographing Handloaded .22 Rimfires - Jim Taylor, 2021-08-05, 09:01
- With LILgun if you have some air-space - WB, 2021-08-05, 10:17
  - when did you have hang fires with full load of powder? - Gary Reeder, 2021-08-05, 14:57
    - If you compress H110 or 296, Lilgun with a cool primer - WB, 2021-08-05, 15:53
      - if it always does it 100% of the time why do you keep on - Gary Reeder, 2021-08-05, 16:47
        I found back when primers were scarce - WB, 2021-08-05, 19:02
        remember every reloading book will tell you to use a - gary reeder, 2021-08-05, 22:17
    - GNR is right. At a match in Alabama I saw - Jared, 2021-08-05, 15:10
    - The priming in these .22's seems "light" .. - Jim Taylor, 2021-08-05, 15:02
  - These were not a compressed load... - Jim Taylor, 2021-08-05, 11:03
    - Lil'gun can be hard to ignite. - WB, 2021-08-05, 13:16
      - if that powder causes problems, like GNR said, why not - James Pedigo, 2021-08-05, 17:38
      - The cases Denning sent me are steel. Pretty strong. (nm) - Jim Taylor, 2021-08-05, 13:50
- If you need more bullets just say so , I have plenty. (nm) - Sean Harper, 2021-08-05, 09:57
  - I could use some more of the 40 gr. FN bullets Sean - Jim Taylor, 2021-08-05, 11:05
    - Going out tomorrow (nm) - Sean Harper, 2021-08-05, 12:29
      - Thank you Sean! (nm) - Jim Taylor, 2021-08-05, 12:35

powered by my little forum