there IS a difference. I think my oversize bullets for the bore and pistol primers in place of rifle caps caused this. I pulled the other test rounds, only a few. That's what testing is about. If it's enough to pop a pistol cap it's too hot for me. The other bullets did not exhibit the same trait.
If you can see in there it's a teeny pin hole. But quite a bit of gas bled out.
-
The devil is in the details...
- WB, 2019-09-19, 06:45
-
Lookin good Scotty! Heard the 414 brass is the only way to g (nm)
- Asa, 2019-09-19, 17:29
-
One grain too much H110
- WB, 2019-09-19, 17:59
-
"mildly pierced"? That is sorta like barely pregnant (nm)
- Gary Reeder, 2019-09-20, 10:56
- Unfortunately I have experienced actual BLOWN primers - WB, 2019-09-20, 13:19
-
I'm dropping a grain, using rifle primers.
- WB, 2019-09-19, 19:40
- Sent ya an email (nm) - Asa, 2019-09-19, 21:11
-
"mildly pierced"? That is sorta like barely pregnant (nm)
- Gary Reeder, 2019-09-20, 10:56
-
One grain too much H110
- WB, 2019-09-19, 17:59
-
Lookin good Scotty! Heard the 414 brass is the only way to g (nm)
- Asa, 2019-09-19, 17:29