Takes a little work to blow them out straight. Graf&Sons is where i got the brass. I use pistol primers in the rifle primer cases. There are YouTube videos for different methods of blowing out the shoulder and neck, and you’ll probably come up with your own technique. A .375 expander to start, with a lathe you could make up a couple more expanders to run the case neck up the rest of the way. Run up to .375, some wadding, some shot and a over shot card that’s 3/8” blows them out in a bolt action .410. I’m rambling again.
-
.410 shotgun useless?!
- WB, 2024-01-26, 09:28
-
9.3x74R is a match for 3” .410 when blown out.
- steve todd, 2024-01-27, 10:45
-
That may be the best for maximum performance
- WB, 2024-01-29, 10:22
- Graf&Sons is out of stock for 9.3x74R - steve todd, 2024-01-30, 17:58
-
That may be the best for maximum performance
- WB, 2024-01-29, 10:22
- The most widely used bore in the Amazon - AmBraCol, 2024-01-27, 07:05
-
Right now the 410 ammo is about the most sought after
- Gary Reeder, 2024-01-26, 10:34
-
To make all brass .410 cases what do you think
- WB, 2024-01-26, 13:39
- Full brass 410 - AmBraCol, 2024-01-27, 07:13
- Magtech sells .410 brass cases (nm) - Mark Wilson, 2024-01-26, 14:58
-
.444 is close to proper diameter & length. (nm)
- Jim Taylor, 2024-01-26, 14:04
- For shorter shell use .44-40 (nm) - Jim Taylor, 2024-01-26, 14:05
-
To make all brass .410 cases what do you think
- WB, 2024-01-26, 13:39
-
Eley Brothers had a .410 shell
- IC, 2024-01-26, 10:33
-
That is interesting for sure. I must research it more.
- WB, 2024-01-26, 11:54
-
I've read several articles
- IC, 2024-01-26, 13:48
- I forgot about pinfire! They make reloadable pinfire - WB, 2024-01-26, 15:30
-
I've read several articles
- IC, 2024-01-26, 13:48
-
That is interesting for sure. I must research it more.
- WB, 2024-01-26, 11:54
-
9.3x74R is a match for 3” .410 when blown out.
- steve todd, 2024-01-27, 10:45