Reeder Custom Guns - Bang! Bang! Pop!

John W
Bang! Bang! Pop!
Sunday, September 12, 2021, 11:06

This morning I decided to shoot some reloads in my Ruger SRH 480. I got two shots off before I heard the dreaded POP.

Sure enough, a squib load. I have a 325 grain XTP bullet stuck about one inch into the barrel.

Right now I have the revolver upright with the barrel filled with Hoppes. I figure it will help with removing the bullet.

I kind of wished it was a cast bullet as they seem easier to remove.

Bang! Bang! Pop! - John W, 2021-09-12, 11:06
- it could have been one of 3 things - gary reeder, 2021-09-12, 21:53
  - I think the one grain under max load may be the - John W, 2021-09-13, 15:35
    - it shouldn't be. One grain under listed max - Gary Reeder, 2021-09-13, 17:28
- mine would leave the powder in like a column - Lynn, 2021-09-12, 18:30
- Were you using 4227? (nm) - Randy Barnett, 2021-09-12, 12:59
  - WW 296 (nm) - John W, 2021-09-12, 13:16
- do you know why?I gave a few in my .410 GNR --I traced it t - Lynn, 2021-09-12, 12:06
  - I believe a bad primer. Didn't go off. - John W, 2021-09-12, 13:16
    - Magnum primer or standard? (nm) - DinCA, 2021-09-12, 13:30
      - Federal Magnum Match (nm) - John W, 2021-09-12, 13:33
        Did it have a good firing pin lick on the primer? (nm) - Alcorn, 2021-09-12, 17:42
        Yes. Nice and deep. It must have been a - John W, 2021-09-12, 17:47
        What was your powder charge? - Bob Denning, 2021-09-12, 18:55
        Yes. I .did load it one grain under max (nm) - John W, 2021-09-13, 15:34
        probably 90% of my hunting handgun - Gary Reeder, 2021-09-13, 11:58

powered by my little forum