Reeder Custom Guns - you are going to have to go with a roll crimp

Gary Reeder
you are going to have to go with a roll crimp
Monday, February 24, 2020, 10:15

the bullet doesn't have a lead core so it doesn't give a slight bit when the mouth of the brass crimps in. With lead free commi bullets you need to do a real heavy roll crimp. but have your pistol handy to check and see if you are doing too much of a crimp that it bulges the mouth of the case.

Tested a bunch of lead free crap today! - Larryh, 2020-02-23, 17:20
- you are going to have to go with a roll crimp - Gary Reeder, 2020-02-24, 10:15
  - Loaded some 455GNR and 44M with a roll crimp - Larryh, 2020-02-24, 11:02
    - your current 455 and 44 mag dies will do a good - Gary Reeder, 2020-02-24, 12:19
      - Shot a dozen in the 455GNR and 44M today - Larryh, 2020-02-24, 13:18
        "extreme penetrator" - Gary Reeder, 2020-02-24, 13:42
        Latex and lead free! (nm) - Larryh, 2020-02-24, 13:49
- You can also try "Cutting Edge Bullets". (nm) - DinCA, 2020-02-24, 05:34
- Use a smaller diameter neck expander. - Jim Taylor, 2020-02-23, 21:01
- I have been experimenting with the Barnes in 410GNR. - DinCA, 2020-02-23, 19:11
- Are you seating to the front of the crimp groove? - steve todd, 2020-02-23, 17:36
  - Yep, in the groove. (nm) - Larryh, 2020-02-23, 17:41
    - Thinking roll crimp, maybe? (nm) - Larryh, 2020-02-23, 17:42
      - Yup, heavy roll crimp - steve todd, 2020-02-23, 18:46