Reeder Custom Guns - Gary, I know I have seen mention of some new

cartridges like the 250 GNR below. So you have a list of the new ones?

been around for nearly 2 years. here are some of the new ones...
First the 221 Falcon..shown with a 223 in the middle
[image]
The 241 Falcon,, 30-30 necked down to 243
[image]

321 GNR on the left, next to a 327 Federal on the right. A lot more power than the 327 Federal.
[image]

338 Falcon on the left, 361 Falcon on the right
[image]

L to R..375 GNR#2, 376 GNR, 378 GNR
[image]

470 GNR on the left, 500 Linebaugh necked to 475, 501 GNR on the right, 500 Linebaugh necked to .500.
[image]

There is also the 251 Falcon which is an improved 25-20 but I sent all the brass to Sean for the testing so I don't have one to show.
There are also one or two more that we are in the testing stages on right now.

Post reply

- No text -

Post reply

Please excuse the question!!!What is the .321 as far as case an bullet dia/bullet weight? Thanks

Post reply

.311-.312 diameter bullets. Do not remember barrel length, but Sean achieved 1900fps with 125gr bullet.

Post reply

Ok thanks...Next question can the .321 gnr be built on a single six frame in say a 5 shot?

Post reply

The problem is the loading gate recess. The 357 magnum case that the 321 is based on is too wide to normally go thru the recess without taking a lot of metal out. But that entails breaking into the opening where the transfer bar goes. We are trying to re-weld the recess and have just enough opening to get the 357 rim thru the opening. It works fine with an old model that does not have the transfer bar but is still causing problems in the new model.

Post reply

- No text -

Post reply

I bought the 321 in a varmint hunter revolver at Christmas. Was able to shoot several hundred rounds through it of different loads. Extremely impressed with both gun and round. Have been busy with helping friend with health issues for past few months. Looking forward to hunting with it and 356. The 321 is a 32 caliber fans dream hunting handgun. Accurate with wide range of loads. Beats 327, great cartridge design

Post reply

The problem is the loading gate recess. The 357 magnum case that the 321 is based on is too wide to normally go thru the recess without taking a lot of metal out. But that entails breaking into the opening where the transfer bar goes. We are trying to re-weld the recess and have just enough opening to get the 357 rim thru the opening. It works fine with an old model that does not have the transfer bar but is still causing problems in the new model.

Thanks Gary waiting to see

Post reply

Gary, I know I have seen mention of some new

the 250 GNR isn't one of the real new ones as it has

Think my next one will be a 321 GNR

.321

.321gnr is a .357 necked down to .308. You can also shoot

.321/ next question

we are experimenting with a Trail Gun in 321 GNR right now

Have an OM just waiting...

321

321