321 GNR

Kevin Pflaum
[subject]
Thursday, May 18, 2017, 14:22 (127 days ago)

Gary, I would like to know where you are at with the 321 GNR. I have seen on the forum where Sean worked up load data and you stated that you had ordered dies. What I was thinking is a Howdah revolver chambered in 321 GNR on your Med flat top frame. Another question is if that could be a 8 round cylinder or not on your frame. Also time frame of dies, revolver and data, I know that building the revolver would be 4 to 6 months. Would the dies and data be ready by the time that the revolver was finish? Thanks.

Kevin, the dies should be here within a month. They were

Gary Reeder
[subject]
Thursday, May 18, 2017, 14:53 (127 days ago) @ Kevin Pflaum

ordered before Christmas. The 8 shot won't fit in the cylinder but we do 7 rounds in there with no problems. We should have the dies and data in here by mid June and the revolver in the 4 to 6 month timeframe.

I'm thinking similar. A 7-Shot 307 GNR on a Maximum...

Huey
[subject]
Thursday, May 18, 2017, 15:30 (127 days ago) @ Gary Reeder

Frame.

like this?

Gary Reeder
[subject]
Thursday, May 18, 2017, 16:17 (127 days ago) @ Huey

Pretty much. Fit the left over cylinder to my DMax and...

Huey
[subject]
Thursday, May 18, 2017, 16:21 (127 days ago) @ Gary Reeder

Rechamber to 430 GNR. That long cylinder sure does open up a world possibilities.

powered by my little forum