I had to look him up and it looks like Graf sells his bullets. Some of his designs are similar to the SSK design with the short nose.
I like the SSK design by JD Jones for heavy bullets. I have his moulds for 357, 41 and 44. It is a bore ride bullet and all the ones I tested were very accurate.
The first mould I bought from him was a mistake and had the 225 and 275 grain in the same mould instead of a two cavity 275 so I just kept it.
It is too bad Peter Pi stopped making the moulds. Maybe it was due to the competition with selling his bullets??
-
Cast bullets for 41GNR #2 revolver
- Tim, 2018-02-17, 16:40
-
Beartooth & Leadhead bullets.
- DinCA, 2018-02-17, 22:15
- DinCA, Thanks I will take you up on that - Tim, 2018-02-18, 07:34
-
the original .410 bullets at CPB were different than
- Gary Reeder, 2018-02-17, 20:14
-
Gary, in this one case then, you would
- jthomson, 2018-02-18, 19:53
- the CPB 255 grain .410 bullet is an excellent bullet - Gary Reeder, 2018-02-20, 11:11
- His bullet design is similiar to the SSK - Harry, 2018-02-18, 17:05
- Beartooth Bullets - IC, 2018-02-17, 21:07
-
Gary, what do you consider the max
- Tim, 2018-02-17, 20:40
- the actual length of the cylinder, not counting - Gary Reeder, 2018-02-17, 22:48
-
Thanks for the info Gary (nm)
- Tim, 2018-02-17, 20:35
-
that old original CPB bullet was a great bullet. I used it
- Gary Reeder, 2018-02-17, 21:01
-
.41 bullets
- Alcron, 2018-02-18, 14:59
-
the nose on that bullet looks awful long. Does it fit
- Gary Reeder, 2018-02-18, 22:24
- Not in Guns - Alcorn, 2018-02-19, 03:09
- Thats what I use in my 410GNR also..great bullet (nm) - Woody, 2018-02-18, 20:31
-
the nose on that bullet looks awful long. Does it fit
- Gary Reeder, 2018-02-18, 22:24
-
.41 bullets
- Alcron, 2018-02-18, 14:59
-
that old original CPB bullet was a great bullet. I used it
- Gary Reeder, 2018-02-17, 21:01
-
Gary, in this one case then, you would
- jthomson, 2018-02-18, 19:53
-
Beartooth & Leadhead bullets.
- DinCA, 2018-02-17, 22:15