Kevin Pflaum
321 GNR
Thursday, May 18, 2017, 14:22

Gary, I would like to know where you are at with the 321 GNR. I have seen on the forum where Sean worked up load data and you stated that you had ordered dies. What I was thinking is a Howdah revolver chambered in 321 GNR on your Med flat top frame. Another question is if that could be a 8 round cylinder or not on your frame. Also time frame of dies, revolver and data, I know that building the revolver would be 4 to 6 months. Would the dies and data be ready by the time that the revolver was finish? Thanks.


powered by my little forum