I hope to make it a requirement before issuing a state certification and a P.E. Any prospective applicant, no matter if they stand or sit to pee. They must successfully replace the hydraulic drive belt on a BAD BOY ZT series (not confused with the deck belt) while wedged under a rose bush, using only a crescent wrench, long craftsman regular screwdriver, and a crowbar. If you can’t do that NO P.E. Stamp!
-
If I ever get appointed to a state engineering board…
- WB, 2025-07-29, 17:00
![[*]](themes/default/images/complete_thread.png "Open whole thread")
-
I'm not a PE,
- IC, 2025-08-02, 13:42
-
When that hydraulic belt goes, you is just there. (nm)
- WB, 2025-08-04, 10:21
- I don't know. - IC, 2025-08-04, 12:25
- a very good point Irv, or use a pocket knife for a screwdriv (nm) - jthomson, 2025-08-02, 13:45
-
When that hydraulic belt goes, you is just there. (nm)
- WB, 2025-08-04, 10:21
-
I'm not a PE,
- IC, 2025-08-02, 13:42