Reeder Custom Guns - I’m not sure. BTW .50 Special would work fine too.

WB
I’m not sure. BTW .50 Special would work fine too.
Thursday, July 10, 2025, 18:40

If you could find that. .510 is a bit shorter than the .500 Linebaugh, all three .510-.512” bore cartridges. My .510 prefers .510”-.511” cast bullets. Some of my molds dump them out raw up to .515”. I use a Lyman 450 to run them to .512” then a Lee die to get .510”.

510 GNR - Dobbins, 2025-07-10, 14:17
- I do hope somebody will start loading the 510 GNR - Gary Reeder, 2025-07-14, 16:15
- I’m not sure. BTW .50 Special would work fine too. - WB, 2025-07-10, 18:40
  - 50 Special is .500 diameter. I went that route for the - Darryl T., 2025-07-12, 14:32
    - I think Sir Boggs was referring to - Bob D, 2025-07-13, 20:52
      - Gary made me a gun in 500 special - Bob D, 2025-07-13, 21:01
        Yes, thankd Bob. .50 Bowen Spec. is a stubby - WB, 2025-07-14, 11:41