Reeder Custom Guns - Just a barrel fitting, bore through, refinish

WB
Just a barrel fitting, bore through, refinish
Monday, October 11, 2021, 13:13

Lots of labor in the barrel but the .45 Colt just needs the cylinder throats bored out. Refinish would be about as costly as the barrel.

It’s basically a modified .45 Colt with a .475” barrel on it.

A Sunday Afternoon .... - Jim Taylor, 2021-10-10, 17:21
- On your bullet lubing/coating. I may be confusing - Zollie, 2021-10-11, 10:32
  - Yes .. I have used the alox and mica .... - Jim Taylor, 2021-10-11, 12:47
- Since this is a custom low pressure round - WB, 2021-10-11, 08:25
  - That would be a cool conversion! (nm) - Jim Taylor, 2021-10-11, 10:00
    - OWWW! (nm) - Your Bank Account, 2021-10-11, 10:26
      - Just a barrel fitting, bore through, refinish - WB, 2021-10-11, 13:13
- Looks like a nice way to spend a Sunday Afternoon - steve todd, 2021-10-11, 05:53
  - This one is an Uberti. (nm) - Jim Taylor, 2021-10-11, 06:25
    - Good to know, Thanks Jim - steve todd, 2021-10-12, 06:02

powered by my little forum