Reeder Custom Guns - It took me a while to understand I was not

WB
It took me a while to understand I was not
Thursday, September 23, 2021, 07:56

trying to conform to a spec. drawing, that was the incorrect attitude. Rather, I needed to make it fit my specific rig, then reproduce them. It mattered none what the dimensional numbers were, only that it worked. Same as making parts for guns, don't replicate the old part, make the new one fit and work. A much better result.

6.5 GNR - Ronnie P, 2021-09-22, 11:29
- There are some other “wildcat” 6.5 on the .30-30 - WB, 2021-09-22, 12:48
  - WB - BUCKWHEAT, 2021-09-22, 14:07
    - Just chucked them in the lathe, turned rims till - WB, 2021-09-22, 16:05
      - KINDA FIGURED THAT - BUCKWHEAT, 2021-09-22, 16:26
        SETUP IS WHAT I MEANT - BUCKWHEAT, 2021-09-22, 16:28
        I figured a method on the chuck depth - WB, 2021-09-22, 17:44
        MY METHOD - BUCKWHEAT, 2021-09-23, 04:19
        It took me a while to understand I was not - WB, 2021-09-23, 07:56
        I CANT SEE IT ANY OTHER WAY - BUCKWHEAT, 2021-09-23, 08:24
      - I made up about 40. 20 fir 6.5 Merrill - WB, 2021-09-22, 16:11