Then referenced the X/Y indices on the table. In reality as you cut the brass eyeballing will get you within a thousandth or so. The objective is to get it to work, extract. I was not going to keep the calibers but wanted to experience them.
-
6.5 GNR
- Ronnie P, 2021-09-22, 11:29
-
There are some other “wildcat” 6.5 on the .30-30
- WB, 2021-09-22, 12:48
-
WB
- BUCKWHEAT, 2021-09-22, 14:07
-
Just chucked them in the lathe, turned rims till
- WB, 2021-09-22, 16:05
-
KINDA FIGURED THAT
- BUCKWHEAT, 2021-09-22, 16:26
-
SETUP IS WHAT I MEANT
- BUCKWHEAT, 2021-09-22, 16:28
-
I figured a method on the chuck depth
- WB, 2021-09-22, 17:44
-
MY METHOD
- BUCKWHEAT, 2021-09-23, 04:19
-
It took me a while to understand I was not
- WB, 2021-09-23, 07:56
- I CANT SEE IT ANY OTHER WAY - BUCKWHEAT, 2021-09-23, 08:24
-
It took me a while to understand I was not
- WB, 2021-09-23, 07:56
-
MY METHOD
- BUCKWHEAT, 2021-09-23, 04:19
-
I figured a method on the chuck depth
- WB, 2021-09-22, 17:44
-
SETUP IS WHAT I MEANT
- BUCKWHEAT, 2021-09-22, 16:28
- I made up about 40. 20 fir 6.5 Merrill - WB, 2021-09-22, 16:11
-
KINDA FIGURED THAT
- BUCKWHEAT, 2021-09-22, 16:26
-
Just chucked them in the lathe, turned rims till
- WB, 2021-09-22, 16:05
-
WB
- BUCKWHEAT, 2021-09-22, 14:07
-
There are some other “wildcat” 6.5 on the .30-30
- WB, 2021-09-22, 12:48