but I think my itch has been scratched on this one. To me it doesn't seem like a good idea to put something in the middle of my bullet that affects the integrity as much as this did.
By taking more of the center out of the check I see it working more as a copper drive band than a partition. But since none my hp's have ever expanded as deep as the partition I think it is just something I don't need.
Thanks for the good ideas guys but as I said earlier to me I think my answers are in alloy, depth and width of pin and velocity. A fun afternoon anyway, thanks again.
-
Cast hollow points and partitions.
- Mark Conner, 2021-02-22, 15:38
- looks like a two part cast bullet aka Lyman cool (nm) - Lynn, 2021-02-22, 20:27
-
In the early 80’s I experimented with this idea
- Bob Denning, 2021-02-22, 19:32
- Some good ideas Bob, - Mark Conner, 2021-02-22, 21:40
- I seem to recall from my younger years - John W, 2021-02-22, 18:52
-
I have a couple of these, might work
- Darryl T., 2021-02-22, 17:42
- Those punches are sweet! - steve todd, 2021-02-22, 18:14
- Looks like you need a mechanical punch or die too. - WB, 2021-02-22, 16:53