Reeder Custom Guns - In the early 80’s I experimented with this idea

Bob Denning
In the early 80’s I experimented with this idea
Monday, February 22, 2021, 19:32

The key is to punch a larger ragged hole (don’t drill a hole) in the gas check. If you drill a hole the GC will spin around the lead center. Try this technique by putting the GC in both driving bands. Bob

Cast hollow points and partitions. - Mark Conner, 2021-02-22, 15:38
- looks like a two part cast bullet aka Lyman cool (nm) - Lynn, 2021-02-22, 20:27
- In the early 80’s I experimented with this idea - Bob Denning, 2021-02-22, 19:32
  - Some good ideas Bob, - Mark Conner, 2021-02-22, 21:40
- I seem to recall from my younger years - John W, 2021-02-22, 18:52
- I have a couple of these, might work - Darryl T., 2021-02-22, 17:42
  - Those punches are sweet! - steve todd, 2021-02-22, 18:14
- Looks like you need a mechanical punch or die too. - WB, 2021-02-22, 16:53